Search waterheatertimer.org / all results
Search using Find button  

 Tweet button  
How to replace Intermatic clock motor
E-mail: geno03245w@gmail.com

Check clock motor number before ordering
Intermatic boxes are universal
Any Intermatic timer can fit into box, so clock motor can vary

Release mechanism
from box using thumb spring located inside top of box.

Intermatic metal enclosure
Replacement boxes and other Intermatic parts

Timer mechanism
Larger image
Pull out mechanism
clock motor is on back.

Check general condition of gears.
Apply bit of white grease to steel gears.
Clock motor gears are plastic so they will not bind against steel gears.
If clock motor gear is stripped out where it meets steel gear, then the steel gears might have debris that is binding gears to a halt. Clean steel gears.



Look for model number.
Clock motors start with WG or CW etc
WG series clock motor


Convert timer to different bvoltage
Intermatic clock motor>>>>> Intermatic clock motor
Clock motor: model number
Motor held in place with star-head screw
Generally consumes 3 watts of power

Identify clock motor number:
Clocks Motors and accessories/ pdf
Clock motors3 pdf
Buy: T100 series clocks/ applies to T104-103-102-101-105-106; WH40;  T171-172-173-175-175-176; Intematic pool timers & control panel timers
US power grid is 60 Hz
WG1573 208-277V Amazon
WG1570 120V at Amazon
WG1576 480V at Amazon
CW1570 24V at Aplus
European / Asia power grid 50 Hz
WG1571 motor for 50 Hz 120Volt
WG1574 motor for 50Hz 208-277V Amazon
Order T104-50 timer 208-240V 50 Hz     T104-50 at Amazon
Buy: Sprinkler series clock motors/ and T1905-6; T1975-6 clock motors

125Volt WG730 motor at Amazon
208-240volt WG733 motor at Amazon
480V WG736 clock motor at Amazon
WH21
WH21 clock motor WG233-18 from Intermatic
How to wire T1905-6/ T175-6
How to wire sprinkler timers
How to wire T100 T170 and pool series timers
T100 series timers and manuals
T170 series timers and manuals
More clock motors/ Resources
Intermatic box timers and manuals
Intermatic pool timers and manuals
Intermatic control panels
How to wire T100 T170 and pool series timers

Larger image
Clock motor is held with 2 star-screws
Image on left shows typical WH40 and T100 series timers

Remove 2 screws
Buy star screwdriver from auto parts store or hardware store.

Clock wires connect to terminals on front of timer
Make sure clock wires do not interfere with moving parts
Tighten all screws very tight
Keep wires straight
Use solid copper wire
If wiring terminal or end of wire are covered with green, use emery board to clean terminal and sandpaper to clean wire.
Insdulation under screw plate
Larger image
Both wires MUST be same gauge
Straighten each wire
If wire is corroded or overheated, clean the end with sandpaper and wipe with cloth.
If wire has been melted, cut back and reattach, or replace wire.
Tighten screw very tight against copper wire

Use wire connector  
Push on wire connectors
Use push-on wire connectors
3 wires/ or different gauge wires
Join wires with wire connector or push-on connector
Run jumper to screw terminal.
Buy:
Push on wire connectors at Amazon
Red 3P connector (shown) for 10-14 gauge wire
Connector assortment
Resource:
How to select and install wire connector
Fire safety/ Do not put stranded wire under screw plate
Do not install stranded wire under screw.
Problem1: picture shows 2 different gauge wires under screw plate
Problem2: Stranded wire will expand and contract and come loose under screw plate, even if it is the only wire under the screw plate
Attach stranded wire and solid wire with wire connector, and run solid copper jumper wire to screw terminal
Take photo of wires before starting.

Resources:
Timer caught fire
Load ratings for Intermatic timers/ pdf


Larger image
10-3-wire
10-3-wire  12 Ga
10 gauge or 12 gauge?
Compare your wire with short pieces of 10 and 12 gauge wire from local box store

10 gauge for 30 amp breaker.
10 gauge wire can have black-white and sometimes black-red

12 gauge for 20 amp breaker
12 gauge will have black and white wires
.
Resources:
Match color code and amp rating for wire
Basic house wiring
Add black tape when White wire carries voltage (applies to 208 and 240V circuits)
With 120 and 277 Volt circuits, White wire is Neutral, and Black is Hot
With 208 and 240 circuits, both wires are Hot, and both wires carry voltage
Black tape on White wire identifies wire is Hot and not Neutral
How to troubleshoot Intermatic timer

water heater element
Never assume power is OFF
Use non-contact voltage tester on timer, on wire, on outlet to see if power is present.
Press button on tester, if single beep then no power is present. If continuous beep then power is present.
Never stand on bare ground, always stand on dry boards, do not hold or touch anything metal when working on timer or water heater that has power, tape tester leads to wood sticks, never touch wet water heater, or flooded water heater, or timer that had a short or fire without turning power OFF.

Buy:
Multimeters at Amazon
Buy non-contact voltage tester at Amazon
Electric testers at Amazon
Shop Amazon - Industrial and scientific
Shop Amazon - Industrial Electric Products
Override lever
Dial rotates on time Manual override turns Load ON-OFF Load turns ON-OFF Troubleshoot action
1) Yes
Dial rotates on time
If dial is rotating, then electricity to timer is good.
Yes
Load turns on-off with override
Yes
Load turns on-off
No action
Timer working
2) Yes
Dial rotates on time
Yes
Load turns on-off with override
Yes
Load turns on-off
But only when using override
Replace trippers.
Check copper wire at terminals
3) Dial rotates
But not keeping time
Yes
Load turns on-off with override
Yes
Load turns on-off
But not at scheduled time
Replace clock motor.
How to replace clock motor
Check loose wires
Check circuit breaker
Reset clock after power outage
4) Yes
Dial rotates on time
Yes
Load turns on-off with override
No
Turns ON but not OFF -or-
turns OFF but not ON
Replace trippers
Intermatic trippers and parts
5) Yes
Dial rotates on time
NO,
Load does not turn on-or-off,
But override snaps crisp-n-clean
No
Load does not turn on-or-off
Check breaker and power to Load;
Check Load is working
Test for voltage going to load.
Check for loose wires
6) Dial rotates
But stops after tripper passes
Yes
Load turns on-off with override
Yes
Until dial stops
Check Wiring.
Line and Load wires are reversed.
(Line wires are from breaker. Load wires go to electrical device.)
7) NO
Dial not rotating
Yes
Load turns on-off with override
Yes
But with override lever only
Replace clock motor
How to replace clock motor
8) NO
Dial not rotating
No No
Load does not turn on-off
Check wiring
How to wire T100 series
How to wire Sprinkler timers
More timer wiring
Check circuit breaker and power to timer
How to replace circuit breaker
Check wires at terminals
Use nose to smell for burned connection
Burned wires, scroll down on page.
9) Yes/NO
Dial not rotating
Lever is sluggish or stuck and will not move Yes/No
Load does not turn on-off
Turn off power, spray WD-40 on lever and gears, replace clock motor, buy new timer
10) Timer wires are burned and melted
Scroll down on this page
Chart as pdf


Pointer was moved?
T100 series pointer points straight down to 6 o'clock
Sprinkler timer pointers point to 7 o'clock

Lift and rotate dial clockwise until current time lines up with with siilver pointer
How to operate and set T104 timer
How to operate and set T104 timer
How to wire Intermatic T100 series timers
How to wire Intermatic T1905 and T1906
How to wire Intermatic WH40 and EH40 and EH10
How to wire several brands of box timers
T100 series mechanism only
Snap into old box
Buy mechanism and snap into existing box

Necessary only if gears are rusted and manual override lever does not snap crisp and clean.
New trippers and clock motor are cheaper

Larger image
Trippers
Yellow dial rotates as time passes, and the Off and ON trippers push lever that causes timer to operate. Clock motor operates dial and will keep correct time for years.
Image shows typical WH40 and T100 series

Tripper identification numbers
Intermatic 156T1978A tripper
156T1978A

Intermatic R8806P101C Sprinkler timer
Larger image
T8845PV
T8845PV larger image

Sprinkler timers
When planning watering times it is important to understand how the timer works. The timer just turns on-and-off, and each time the timer turns off, the sprinkler valve automatically advances to next zone. So the sprinkler valve is doing the mechanical job of advancing through each zone.

Rain sensor is not supplied with timer. Buy separate rain sensor. The rain sensor plugs into standard outlet. Connect the wires from rain sensor to terminals on timer. Do not apply voltage to rain sensor terminals.

T8845PV has 24Volt transformer with two yellow wires. Connect yellow wires to sprinkler solinoid. Connect 120Volt power to terminals marked Line and Neutral. Line is the black hot wire. Neutral is the white wire. Do not connect power to yellow wires.

Intermatic sprinkler timer manuals and parts and wiring
How to set and troubleshoot sprinkler timers/ pdf

More parts
Intermatic 119T86A Transformer for sprinkler timer
119T86A Transformer at Amazon
Intermatic 156T1950A tripper
156T1950A
156T1950A trippers at Amazon
156T1950A trippers at Intermatic
Intermatic clock motor
Buy clock motors:
240volt WG733 motor at Amazon
125Volt WG730 motor at Amazon
480Volt WG736 for R8800 series at Amazon
Intermatic 124T2097 Plastic-Insulator
124T2097 insulator
124T2097 at Amazon

How to install insulator
All brands of timers including Intermatic sprinkler:
With 120Volts, Line is the black hot wire. And Neutral is the white wire. Connect the black and white wires to terminals marked Line and Neutral.
With 240Volts, both wires from breaker are hot Line wires. L1 and L2. Either hot wire can connect to either terminal without regard to wire color.
Intermatic trippers
Intermatic trippers and parts
Intermatic P1353 timer
Timer segments Troubleshoot plug-in timers
  
Troubleshoot Intermatic Malibu power packs ML power pack trippers
    
Intermatic ST01C
Intermatic EJ500

If lights blink, then timer is wired wrong. See wiring illustrations
Replace Intermatic timer batteries
Gas and electric water heaters Support the economy:
Buy water heaters from my associate links:

50 gallon Gas water heaters at Amazon
40 gallon gas water heaters at Amazon
50 gallon Electric water heaters at Amazon
40 gallon electric water heaters at Amazon
Hybrid / heat pump/ water heaters at Amazon

Resources:
How to install gas water heater
How to install electric water heater
Troubleshoot gas water heater
Troubleshoot electric water heater
Point of use water heaters
Resources:
Troubleshoot Gas valves with manuals
Icon gas valve

How to replace water heater element Waste King disposal
How to wire tankless electric


Install point of use water heater
Titan tankless

Contactors/ relays
Type 1 and type 2 surge protection surge protection
Programmable timers

Woods timers
surge protection
Anode rods anode rods
Recirculation system

Tankless recirculation
Point of use water heater
Install and troubleshoot garbage disposal Waste King disposal
Buy
Electronic parts

Industrial supplies

Tools and home improvement

Home and garden

Hayward pool
Pentair pool

Southwire electric
Buy
Tools

DEWALT
Black and Decker
Stanley
SKIL
Makita
Porter-Cable
Bosch

Irwin Hand tools
Klein hand tools
Fluke electrical testing
Dremel hobby tools

Campbell Hausfeld air powered
Tekton automotive

Powerbuilt automotive
Saws and saw blades
box timers Resource:
Compare box timers
DPDT timers
Intermatic
Control water heater w/ Z-wave
Intermatic control centers Resource:
Intermatic control centers: and parts
Digital control centers and parts
Tork control centers and parts
Subpanels
All control centers and parts
Enclosures
programmable timer Resource:
Programmable timers
Countdown timers
Off delay timers
On delay timers
Timer modules
Din rail
Twin & one-shot
Woods
Intermatic
Tork
Low voltage power packs Recirculation systems
Enter Amazon from my links
Amazon

E-mail: geno03245w@gmail.com
My response might end up in spam folder, check email folders
Waterheatertimer on Twitter