Waterheatertimer.org
is a self-help website
Figure volts amps watts for water heater 9 Ways to save with a water heater Compare 16 ways to control water heater
How to install point of use water heater Point of use water heater
Search waterheatertimer.org / all results
Search using Find button  

 Tweet button  

GE 15207 clock

Back to 15136 wiring
All GE timers and manuals

See Larger
Set timer

48 segments
Segment up = timer off
Segment down = timer on








Compare GE to
Intermatic Mechanical Timer



See Larger
GE clock has 48 segments that are pushed up or down

Plastic arm rides along clock wheel as it turns. Arm snaps-in when segment is up, and this turns timer on. Arm stays out when segment is down, and this keeps timer off.

Min 1/2 hour on-off times

Intermatic mechanical timer has metal pins & parts
Minimum one hour on-off times. Larger image
Intermatic trippers and parts


See Larger
GE 15207 clock mechanism is attached with 3 small phillips screws No image
Intermatic mechanical time mechanism snaps out

See Larger
GE Clock has 3 wires.
Wires have room to be cut and spliced.

Web search for replacement motor shows nothing


Buy Intermatic mechanical clock motors

See Larger
Plastic gears inside clock.
Larger image

See Larger
Back of 125V clock mechanism: BMHD Timer Module

Motor notation is suspect?

Clock notation shows 1/3 HP >> which is 248 Watts ... heat from 248 Watts is more than two100 Watt bulbs ... which would melt plastic housing.

Tim e-mailed and said 1/3Hp is switch rating between Lin and Lout, and does not apply to power consumption of clock motor inside 15207 timer.

Markings on 15207 clock indicate it is not intended for consumer replacement

Intermatic WH40 3Watt clock motor/ 26Kwh per year
Clock remains accurate for years

The intermatic clock motor is designed for ez replacement using WG1573 model number and star screwdriver bit. This clock motor is available from many internet vendors

See Larger
Circuit board comes loose from housing with 4 flat-tip screws
Larger image

See Larger
Circuit board does not have chip or relay or transformer.

Interesting Note: when dip switches are set for 120V, clock circuit has a neutral wire.

When dip switches are set for 240V, and 2 hot wires connect to clock terminals, there is no neutral wire -or- ground wire for the 125V AC clock motor.

Slide bar physically pulls contacts apart and pushes contacts together. No electronics to fail. Larger image
space
Intermatic control centers Intermatic control centers:
+ manuals and parts


Including Z-wave
box timers Compare box timers

Compare ways to control Gas and Electric heaters
Compare 16 ways to control water heaterprogrammable timer Compare programmable timers

Control water heater with programmable wall timer
All GE timers and manualsCountdown timers Compare countdown timers

Control water heater with countdown timer
Compare power packs

E-mail: geno03245w@gmail.com
My response might end up in spam folder, check email folders
Site map
Follow newest idea on twitter
Privacy policy
Search